The table below lists two materials used in graphic products. Complete the table by writing the correct material classification for each material. Choose fr...

Fig 7 shows a rapid prototype model of a new mobile phone case. The model was produced using 3D printing (additive manufacturing). (a)(i) Describe how a 3D p...

Fig 4 shows a flat-pack shelving unit made from manufactured board. The unit has four shelves and two side panels. Each shelf is 600 mm wide and 300 mm deep....

Fig 13 shows a hand-operated food mincer used in a kitchen for processing meat and vegetables. The mincer uses a mechanism to convert the rotary motion of a ...

Fig 2 shows a children's outdoor climbing frame. Several components are made from different polymers. The main hand-grip bars are made from nylon and the sli...

Fig 17 shows a workshop lathe used for turning metal components. (a) (i) State two safety features that should be fitted to the lathe. [2] (ii) Explain why a...

Fig 1 shows standard circuit symbols used in electronic design. A student is designing a light-sensing circuit for an outdoor garden lamp that switches on au...

Fig 11 shows a cross-section through a steel corner bracket that joins two rectangular hollow-section tubes at a right angle. The bracket forms part of a lar...

Fig 8 shows a portable menu holder used in a restaurant. The holder is made from a single piece of clear 3 mm acrylic sheet that has been heated and bent int...