Back to Concepts Of Matter

Oak National Academy

Lessons written by expert teachers in England, each with slides, a video and quizzes.

Their topic:
States of matter · Particle explanations of density and pressure
For your topic:
Concepts Of Matter · Physics

Use these lessons alongside our lesson note, which covers your syllabus in full.

What this covers in your syllabus

3 lessons from Oak National Academy

Lesson 1 of 3 · GCSE level, ages 14 to 16

The particle model

By the end: I can describe the particle model of matter and how it explains the properties of solids, liquids, and gases.

Take the full lesson on Oak National Academy The video, slides and quizzes for this lesson are on Oak National Academy's site.

Key learning points

  1. There are three states of matter: solid state, liquid state, and gas state.
  2. A substance in the gas state can be compressed because there is empty space between the particles.
  3. A substance in the liquid or solid state cannot be compressed because the particles are already touching.
  4. A substance in the gas or liquid state has no fixed shape as the particles can move past each other.
  5. A substance in the solid state will not flow because the particles vibrate in a fixed position.

Keywords

states of matter
The states of matter are used to describe the three physical states that matter commonly exists in: the solid state, liquid state and the gas state.
particle model
The particle model is a model used to explain the physical properties of substances by describing the arrangement and movement of particles.
forces of attraction
Forces of attraction are pulling forces that keep particles close together.
compress
If you compress a substance, it can be made to take up less space than before. Substances in the gas state can be compressed.

A common mistake

Mistake: Pupils often think that the particles are embedded in the substance rather than being the substance. Most pupils think that substances in the liquid state will compress a little.

In fact: Reinforce that most substances can exist in all three states of matter and when they are in the gas state there is nothing between the particles but empty space.

A combined science lesson by Oak National Academy licensed under the Open Government Licence (OGL) v3.0. Read the licence

Lesson 2 of 3 · GCSE level, ages 14 to 16

Pressure in a fluid

By the end: I can explain the causes of pressure in a fluid.

Key learning points

  1. The particles in liquids and gases move very quickly and randomly in every direction; they are both fluids.
  2. Particles in liquids are very close together; the gaps between particles in gases are much larger than the particles.
  3. The pressure at any point in a fluid is the same size in every direction.
  4. The particles in a fluid exert pressure on a surface by colliding with it.
  5. Pressure is calculated using the equation: pressure = force ÷ surface area.

Keywords

atom
the building block of matter; even small pieces of matter have trillions of atoms
particle
a term used to describe atoms or molecules which make up matter
fluid
a liquid or a gas; fluids can flow as the particles can move around each other
pressure
caused by a force acting over an area on a surface; it can be calculated using: pressure = force ÷ area

A common mistake

Mistake: The pressure at a particular depth depends on the shape of the container the liquid is in.

In fact: Demonstrate different shaped containers with the same depth of water in each and an identical shaped hole 1 cm above the base of each. Identical sized jets of water should shoot out of each hole as the pressure at each hole is (initially) the same.

Check what you learned

From Oak National Academy's exit quiz. Choose every answer that is right.

Which of the following statements about particles are correct?
Which of the following statements about fluids are correct?
Which of the following statements explains why it is difficult to compress a liquid?
Which of the following statements explains why all fluids exert pressure?

A physics lesson by Oak National Academy licensed under the Open Government Licence (OGL) v3.0. Read the licence

Lesson 3 of 3 · GCSE level, ages 14 to 16

State changes: fundamentals

By the end: I can describe the processes of melting, freezing, boiling, and condensation, using a simple particle model to explain these state changes.

Take the full lesson on Oak National Academy The video, slides and quizzes for this lesson are on Oak National Academy's site.

Key learning points

  1. A simple particle model explains melting, boiling, freezing, and condensing processes.
  2. Boiling is when a liquid becomes a gas throughout, forming bubbles. Condensation is when gas turns into liquid.
  3. Melting is when a solid turns into a liquid with added energy. Freezing is the reverse: liquid to solid, losing energy.
  4. The particles remain the same size and shape as they do not have bulk properties like melting and boiling points.

Keywords

melting
When a substance changes from a solid state to a liquid state.
freezing
The process of a substance changing from a liquid state to a solid state.
forces of attraction
A pulling force that keeps particles close together.
boiling
When a substance in the liquid state is heated, gas bubbles form and it changes to the gas state.
condensing
When a substance in the gas state is cooled and changes to a liquid state.

A common mistake

Mistake: Pupils often think that the particles within the liquid will have melted or boiled rather than remain the same size and shape, i.e. atoms do not have bulk properties like melting and boiling points.

In fact: Ensure that you specifically say that the particles themselves will not melt or boil.

A combined science lesson by Oak National Academy licensed under the Open Government Licence (OGL) v3.0. Read the licence

The wording comes from each publisher. The layout and the links to your syllabus are ours.