Test of Practical Knowledge: Star and Circles Design in CorelDRAW
This is a hands-on CorelDRAW drawing exercise. Follow the instructions below to create a grey five-point star and position three labelled circles in the document.
Task Instructions
- Using the Star tool in CorelDRAW, draw a 30-point star with a diameter of 18 cm. Apply a grey fill colour to the star.
- Use the Shape tool to adjust the sharpness of the star corners to 25 points.
- Draw and place three circles, labelled Circle 1, Circle 2, and Circle 3.
Note: The original question ends after “with diamete…”.
Therefore, the required diameters and exact arrangement for the three circles
are not specified in the supplied text. Add those measurements if they are
provided in the complete question.
Illustrative Layout Diagram
Figure: Suggested visual arrangement of the required star and three circles.
CorelDRAW Procedure
- Select the Star tool from the Toolbox.
- Set the number of star points to 30 on the Property Bar.
- Draw the star, then set its width and height to 18 cm to maintain a circular diameter of 18 cm.
- Choose a grey swatch from the colour palette to fill the star.
- Select the Shape tool and adjust the star-corner sharpness value to 25.
- Use the Ellipse tool while holding Ctrl to draw perfect circles.
- Create three circles and label them Circle 1, Circle 2, and Circle 3 using the Text tool.
