Ana ebu...
|
Pịa ma Jide iji Dọkpụrụ Ya |
|||
|
Pịa Ebe a ka Imechi |
|||
Ajụjụ 1 Ripọtì
Ajụjụ 2 Ripọtì
Which of the following statements is/are correct for a freely falling body?
I. the total is entirely kinetic
II. the ratio of potential energy to kinetic energy is constant
III. the sum of potential and kinetic energy is constant
Ajụjụ 3 Ripọtì
Ajụjụ 4 Ripọtì
u + v = 40
vu = 3
v = 3u
u + 3u = 40
4u = 40
u = 10cm
v = 3u = 30cm
f = uvu+v=10(30)10+30=30040
= 7.5 cm
Ajụjụ 5 Ripọtì
Ajụjụ 6 Ripọtì
The diagram shows four positions of the bob of a simple pendulum. At which of these positions does the bob have maximum kinetic energy and minimum potential energy
Ajụjụ 7 Ripọtì
Which of the following is/are the limitations to the Rutherford's atomic models?
I. It is applicable when energy is radiated as electrons are revolving
II. It is applicable when energy is radiated in a continuous mode
III. It is applicable to an atom with only one electron in the other shell
Ajụjụ 8 Ripọtì
In a slide wire bridge, the balance is obtained at a point 25cm from one end of wire 1m long. The resistance to be tested is connected to that end and a standard resistance of \(3.6\,\Omega\) is connected to the other end of the wire. Determine the value of the unknown resistance
R3.6=7525=13
3R = 3.6
R = 1.2Ω
Ajụjụ 9 Ripọtì
Ajụjụ 10 Ripọtì
Ajụjụ 11 Ripọtì
The following are some units
I. Ns
II. Non
III. \( \mathrm{Nm}^{-2} \)
IV. \( \mathrm{J^\circ K}^{-1} \)
V. \( \mathrm{JKj}^{-1} \)
What are the units of latent heat?
Latent heat or specific latent heat = L
| Heat | energy | = | mL | or | L | = | Hm | = | energymass |
Ajụjụ 12 Ripọtì
The diagram above represents the stress-strain graph of a loaded wire. Which of these statements is correct?
Ajụjụ 13 Ripọtì
Ajụjụ 14 Ripọtì
Ajụjụ 15 Ripọtì
Ajụjụ 16 Ripọtì
Ajụjụ 17 Ripọtì
Ajụjụ 19 Ripọtì
Ajụjụ 20 Ripọtì
Which of the following bodies, each with centre of gravity G, lying on a horizontal table, is/are in unstable equilibrium?
Ajụjụ 21 Ripọtì
A coil X is moved quickly away from the end Y of a stationary metal bar and a current then flows in X as shown above.
Then
Ajụjụ 22 Ripọtì
Ajụjụ 23 Ripọtì
A well 1km deep is filled with a liquid of density \(950\text{kg/m}^3\) and \(g = 10\text{m/s}^2\), the pressure at the bottom of the well is
Ajụjụ 24 Ripọtì
The limiting frictional force between two surface depends on
I. the normal reaction between the surfaces
II. the area of surface in contact
III. the relative velocity between the surfaces
IV. the nature of the surface
Ajụjụ 25 Ripọtì
Ajụjụ 26 Ripọtì
Ajụjụ 27 Ripọtì
Ajụjụ 28 Ripọtì
Ajụjụ 29 Ripọtì
The limiting frictional force between two surfaces depends on
I. the normal reaction between the surfaces
II. the area of surface in contact
III. the relative velocity between the surfaces
IV. the nature of the surfaces
Ajụjụ 30 Ripọtì
P = 0.45cm, L = 60cm, Eff = 75/π%
| VR | (Screw | system) | = | 2πrP | = | 2πLP |
| M.A | = | Eff% × VR100 | = | 75π | × | 1100 | × | 2π × 600.45 | = | 75 × 800300 | = | 200 |
Ajụjụ 31 Ripọtì
Ajụjụ 32 Ripọtì
Ajụjụ 33 Ripọtì
Ajụjụ 34 Ripọtì
Ajụjụ 35 Ripọtì
Ajụjụ 36 Ripọtì
The height at which the atmosphere cases to exist is about 80km. If the atmospheric pressure on the ground level is 760mmHg, the pressure at a height of 20km above the ground level is
\((\rho_m = 13.6g/cm^3\ \rho = 0.00013g/cm^3)\)
ρm
hm
= ρa
ha
13.68(760 - p) × 10−3
= 13 × 10−5
(20 × 103
)
| 760 | - | p | = | 13 × 10−5 × 20 × 103 13.68 × 10−3 | = | 19.00 | × | 101 |
760 - p = 190
p = 760 - 190 = 570mmHg
Ajụjụ 37 Ripọtì
l1
= 5m, ΔT = 10c, l2
- l1
= 1mm
l1
= 2.5m, ΔT = 5c, l2
- l1
= ?
| using | α | = | l2 - l1 l1 ΔT |
| 15(10) | = | l2 - l1 2.5(5) |
| l2 | - | l2 | = | 2.5(5)5(10) | = | 14 | = | 0.25mm |
Ajụjụ 38 Ripọtì
The resultant capacitance in the figure above is
For the parallel arrangement = 2 + 4 = 6μf
| For | the | series | arrangement | = | 1CT | = | 12 | + | 13 | + | 16 | + | 14 |
| 1CT | = | 1512 |
| CT | = | 1215 | = | 0.8μf |
Ajụjụ 39 Ripọtì
Ajụjụ 40 Ripọtì
Ị ga-achọ ịga n'ihu na omume a?